General Contractors | Basement Finishing Contractors Colorado Springs

general contractors colorado springs

Looking for the Best General Contractors or Basement Finishing Contractors in Colorado?

Home is where the heart is and the heart always has an inclination towards well-made and maintained things. This is the reason why you must make all the efforts to hire the best possible team when thinking of remodeling your home.

It requires a lot of time and effort and remodeling of a house is not something that is done very often.

how much does a finished basement cost

While you can be fully prepared with design ideas, budget, and interior decoration, hiring a home contractor can be a difficult task and requires one to keep the following things in mind when hiring one:

Get Recommendations:

Friends and family can be really helpful while looking for a home contractor. All those who have recently got a renovation done must have done a lot of research on hiring a home contractor.

Set A Payment Schedule:

While going through the contract, one of the most important details to take notice of is the payment schedule which should be decided upon by mutual agreement of the two parties.

It is imperative to discuss and come to a point of agreement with the home contractor about the schedule to avoid any sort of discrepancy and/or delays that may occur in the later stages of the renovation.

Basement Finishing Systems

basement project

Basement finishing sometimes requires putting up a stud wall. Tailing up the studs that will form the structural support for the new walls of your remodeling job is a highly satisfactory task. It will be accomplished quickly.

The next task when basement finishing with a stud wall is to measure along an existing wall to the point where the new partition will connect. Drive a nail into the floor at this spot. Tie one end of a chalk line onto the nail. What's a chalk line? It's a length of tough builder's twine that's been rubbed across a big lump of carpenter's chalk. If you want to get fancy, you can buy the same deal on a little reel affair that is filled with chalk dust. In either form the gadget is a very handy marking device.

Reel off enough chalk line to take you out to the end of your new partition wall. At this point, you really need an assistant to hold the line taut; sometimes basement finishing requires more than two hands. Place a large carpenter's square so that one leg lines up with the old wall and the corner of the square rests up against the nail that you've just driven into the floor. Jockey your line back and forth until it is aligned perfectly with the other leg of the square. Stretch it taut, pull it up at the center and let it snap down to make a neat chalk line along the floor.

Select a nice straight 2x4. It should be long enough to reach from floor to ceiling minus about 1 in. Sight along the side of the timber to make sure that it's straight because this piece of wood is a measuring stick of sorts. Here's how to use it for your basement finishing task.

Rest the bottom end of your measuring stick against the side of the shoe. Hold it in place with your foot. The top edge of this timber rests against the side of the plate and you hold it there with your hand. With your other hand, hold a level flat against the side of the measuring stick.

Jockey the whole works back and forth until the bubble in the level is centered, then nail the loose end of the plate to the ceiling. If you've been lucky enough to locate an absolutely straight stud as a measuring stick, mark it carefully and put it aside so that you can use it for the same job later on. That'll make your basement finishing easier.

You should end up with a satisfactory stud wall.